1000 Litre Twin Axle Aircraft Toilet Vacuum Tanker

TANK: Cylindrical in section constructed from 4mm stainless steel, fitted with an internal partition, 200L Chemical tank with 2” filler and cap, connected to a 12V pump fitted with an in line pressure relief valve, with a spring rewind hose reel and 30ft of 1” hose with a breakaway coupling in line and a 1” aircraft toilet water connector, 3 chemical resistant content sight glasses in end of tank 800L Effluent tank fitted with 4” discharge valve in base of tank c/w cap and chain, 3 content sight glasses in the end of the tank .Bolt on access manlid, 3” top mounted screw cap to allow pressure washing of effluent compartment. 4” swivelling tank top connection with Knife valve c/w 12ft of 4” suction hose with a toilet connector unit fitted on hose end, hose stowed on brackets on side of tank. Pressure/ Vacuum relief valve in tank top, Vacuum gauge in tank top PUMP: MEC 1600Lpm vacuum pump fitted with auto lube, driven via belts .fitted with a high level auto cut out ball and a secondary cut out in the pump line. 2 charcoal filter units fitted on exhaust outlet of pump to remove odour. ENGINE: 10HP electric start Changfa single cylinder diesel engine fitted with secondary exhaust smoke filter unit. Back up recoil hand start fitted. Push button glow plug cold start fitted to engine for cold weather use. BATTERY / ELECTRICAL EQUIPMENT: 100AH heavy duty leisure battery fitted in steel locking box c/w master switch. Split level charging unit fitted to battery c/w cable and ISO plug to enable charging of trailer battery from towing vehicle. 110/240 V 12 volt battery charger fitted in battery box c/w mains lead. Consumer unit fitted with 2 RCD switched fuses connected to trace heating and immersion heater, and battery charger 110V trace heating fitted to external chemical pipe work c/w insulation, 110V 1000 Watt immersion heater fitted into base of front chemical tank, Air temperature sensor unit fitted externally on trailer to switch trace heating on and immersion on when plugged into 110V power supply. TRAILER: CHASSIS: Constructed from 5mm pressed steel section fully welded with a 100 x 50 RSC ‘A’ frame drawbar and front standing plate. AXLE/SUSPENSION: Twin Knott-Avonride 1500kg torsion beam axles fitted with 200 x 50 Auto reverse brakes. WHEELS AND TYRES: 4 No. 185 /13 x 8 Ply tyres on 4 stud rims. ANCILLARY EQUIPMENT: full road lighting, parking brake and auto reverse brakes, Telescopic front jockey wheel, 50mm ball coupling, moulded mudguards, Amber airport approved flashing beacon mounted on tank top. 4 tread access step ladders stowed on brackets on side of trailer. DIMENSIONS: Height 2090mm Width: 1510mm Length: 4360mm